Cisco Exam #642-831: CIT Exam (Transcender, set 2)
Test your skills and knowledge on troubleshooting sub-optimal performance in a converged network environment for Cisco's CCNP certification with these 10 practice questions.
courtesy of Transcender
Question:
1. What command can be used to view all Address Resolution Protocol (ARP) table entries in cache?
2. What command can be used to display entries in the BGP routing table?
3. What debug command can be use to display information about ICMP transactions?
4. At which OSI layer does CDP function?
5. Which command should you enter at the command prompt to delete the 10.10.10.10 ARP entry from the ARP table on a Windows XP system?
6. What device configuration problem typically causes excessive late collisions?
7. During which stage of the general troubleshooting process does the troubleshooter build a knowledge base about the potential reasons for a problem?
8. Which device is used to test physical network connectivity, near-end crosstalk, attenuation, and noise?
9. Which command should you use to display current Frame Relay map entries?
10. Which bits, when set on a Frame Relay frame, indicate network congestion?
1. show ip arp
2. show ip bgp
3. debug ip icmp
4. Data-link
5. arp -d 10.10.10.10
6. duplex mismatch
7. gathering symptoms
8. cable tester (scanner)
9. show frame-relay map
10. BECN, FECN
Questions and answers provided by Transcender. To order the full version of this exam simulation, click here.
More Pop Quiz:
|
